Industrial/Commercial Boiler/HVAC Servicing & Installation throughout the Bay Area, Sacramento and Northern California
We do it all
Our technicians can provide:
- Replacement parts
- Emergency visits
- Ongoing service & maintenance plans
- Boiler emissions monitoring
- Reducing fuel costs
- Boiler rental hire
- Burner replacement
- Boiler replacement
- Controls replacement
- Quotes/recommendations
- Connectivity of multiple boiler locations via MODBUS/BMS
Boiler Upgrades that Pay Off
We offer automated systems that can reduce oil/gas consumption by up to 35%, eliminate 90% of maintenance headaches, significantly reduce emissions and pay for themselves in as little as one year.
These improvements are possible when transitioning away from older linkage systems and antiquated burners to modern systems. However, even fairly modern installations can often see significant fuel and emissions improvements with our upgrades.
Small & Large
We support all site sizes:
- Small:
- Offices
- Churches
- Hotels
- Breweries
- Schools
- Large:
- Factories
- Universities
- Hospitals
- Multi-site:
- Corporate-wide
- International
Featured Product: Autoflame Touchscreen Boiler Controls
Autoflame gives users a wide variety of controls and reporting features for their boilerhouse.
One Source Engineering has a number of these installations in the field, and can bring you and your team on-site to see them in action.
TDS/Top Blowdown
System drains water near the surface based on TDS (Total Dissolved Solids) readings from a probe. It continues to drain water (which is then refilled by a feedwater valve) until the probe determines that the water has reached prescribed TDS levels. The engineer can also choose to set Top Blowdown at timed intervals instead.
Flame Safeguard
Pause here for 7 seconds to view stages of Flame Safeguard
VSD Control
Control fan motor speed for greater efficiency
Water Level Control
System safety is guaranteed as water level measurement is managed by two identical capacitance probes, both of which measure and control to the level switching points entered at the time of commissioning. The probes support up to 7 switch points (High level, 1st Low Level, 2nd Low Level, etc). The points trigger feedwater activation, alarms or lockouts, depending on commissioning.
Bottom Blowdown
Prevents sludge buildup at the bottom of the boiler by rapidly draining water at prescribed intervals.
Steam Flow Metering
Adding steam or heat flow metering to a Mk7 with expansion board is as simple as optioning it in. Additional sensors increase accuracy. Once enabled, user has access to: • Instantaneous steam & heat flow • Gross/Net heat flow in the boiler calculated & displayed • 24 hours of logged heat flow stored internally • 2 years of heat flow data available on the Mk7 DTI • Online analysis including instantaneous/totalised values, data logging & graphical display on the MM Controller & DTI • Displayed in lbs/hr or kgs/hr
Dual Fuel
The current unit is configured for both oil (red line) and natural gas (yellow line - currently active) fuel operation. If this were configured for single fuel, one of these lines would not be visible.
EGA: Total Emissions & Fuel Costs
Featured Product: Limpsfield Burners
Limpsfield industrial burners are guaranteed with 3% O2 emissions when firing gas, while producing negligible CO, and with a maximized efficiency.
Upgrading your boiler to a Limpsfield burner could save up to 15% on your annual fuel bill.
Thank you to Trojan Energy Systems for hosting a brilliant training school in Buffalo, NY. Great 2 days focusing more on operator training with loads of hands-on exercises and guided lessons. And let’s not forget the Buffalo wings! The post Trojan Training School first appeared on Autoflame. The post Trojan Training School appeared first on Autoflame. [...]
Just finished up an intense couple of days of training with Jason Paxson of Combustion Systems Inc. and Intel’s Rio Rancho operator team in Albuquerque NM! ⛰️ Tom and Steve customised the course to the exact Autoflame and Limpsfield equipment on-site, yielding the most effective... The post Intel Training School first appeared on Autoflame. The post Intel Training School appeared first on Autoflame. [...]
SEI SAS and American Burners visited Autoflame HQ this week for Tech Centre Training at BK Labtech. It was great to see you Jorge, Luilio, Paula and Fernando! The post SEI SAS and American Burners Visit first appeared on Autoflame. The post SEI SAS and American Burners Visit appeared first on Autoflame. [...]
It was great to see Andrew Cremers from CCI Combustion Control Inc. on his visit to the Autoflame offices yesterday. Andrew travelled from British Columbia, Canada to see us! 🇨🇦 The post CCI Combustion Control Inc. Visit first appeared on Autoflame. The post CCI Combustion Control Inc. Visit appeared first on Autoflame. [...]
We are excited to welcome Enerlite Elite Energy Performance , our new exclusive Tech Centre for Portugal! 🇵🇹 Welcome to the Autoflame network, We look forward to working with you! The post New Autoflame Tech Centre for Portugal first appeared on Autoflame. The post New Autoflame Tech Centre for Portugal appeared first on Autoflame. [...]